Support
iDrive Troubleshooting
iDrive (* 1 iDrive per motor*) The iGROW is just dry switching contacts that the iDrive receives. Master into a Slave On the J2 PCB #3  (to 24VAC transformer) remove and INDEPENDENTLY cap off. Slave - Make into a Slave J1 on circut board (9 - 10 ...
iDrive 300 - Swapping Out The Thermal Overload
If your Thermal Overload becomes problematic always tripping not allowing power to go thru it. its time to swap the Thermal out and here is a video link explaining the process: iDrive 300 Swapping Out The Thermal Overload Here is the link to the ...
iDrive 300 Standard PCB - Testing OPEN - CLOSE Manual Switch
If your iDrive 300 Manual switch may be giving your some issues and here is a process in testing the switches functionality. Please view the following video link to show you the process of testing the switch. iDrive 300 Testing OPEN - CLOSE Manual ...
iDrive 300 - Thermal Overload Testing
If your iDrive 300 Thermal Overload is always tripping it is time to look at a few things. Compare the Motor Running Current Draw with the Size of the Thermal Overload that came with the iDrive Most AC Motors have on there Motor Spindle a Plate that ...
iDrive 150 Small PCB - Testing OPEN - CLOSE Manual Switch
If your iDrive 150 Manual switch may be giving your some issues and here is a process in testing the switches functionality. with your testing you will have to have your meter leads ant the 2 soldering point locations to determine continuity or DC ...
iDrive 300 Standard PCB - Testing AUTO Control Terminal Points
view the following process in testing your iDrive PCB to see if the Automated function is working properly. when controlling your AC Motor, its good to test the AUTO function to ensure the motor controller is working properly.
Connecting an iDrive with a Thermostat
IDRIVE – to - THERMOSTAT To wire the iDrive to a Thermostat, it would have to be a two-stage low voltage thermostat that can dry switch the OPEN, CLOSE and COMMON (J1 1/2/3) Terminals on the Master iDrive based on a temperature setting. You would ...
Daisy Chaining iDrive 150 DCP
Can the iDrive 150DCP be daisy chained like the 300M’s? The answer is yes, but you still need to remove the 24V and COM from the slave iDrive PCB.
iDrive 150 DCP
Attached is the Drawing for iDrive 150 DCP
iDrive - 970-0013-XXM Single Phase 3 wire
Attached is wiring information associated with the model number you provided 970-0013-xxM If you’re attaching the iDrive to a Ridder Motor, we do have videos on how to set the Limit Switching Ridder Motors I - Overview & Wiring a Ridder Motor Ridder ...