Daisy Chaining iDrive 150 DCP

Daisy Chaining iDrive 150 DCP

Can the iDrive 150DCP be daisy chained like the 300M’s?
 
The answer is yes, but you still need to remove the 24V and COM from the slave iDrive PCB.

    • Related Articles

    • iDrive 150 DCP

      Attached is the Drawing for iDrive 150 DCP

    • iDrive Troubleshooting

      iDrive (* 1 iDrive per motor*) The iGROW is just dry switching contacts that the iDrive receives. Master into a Slave On the J2 PCB #3 &#2 (to 24VAC transformer) remove and INDEPENDENTLY cap off. Slave - Make into a Slave J1 on circut board (9 - 10 ...

    • iDrive - Dasiy Chaining Mulitple iDrives for Simultaneous Operation

      Converting iDrive MASTER into a iDrive SLAVE To convert a iDrive Master into an iDrive Slave you would do the following: · On the J2 portion of the PCB board on the door of the iDrive · Remove the #3 & #2 (to 24VAC transformer) and INDEPENDENTLY cap ...

    • iDrive - 970-0013-XXM Single Phase 3 wire

      Attached is wiring information associated with the model number you provided 970-0013-xxM If you’re attaching the iDrive to a Ridder Motor, we do have videos on how to set the Limit Switching Ridder Motors I - Overview & Wiring a Ridder Motor Ridder ...

    • iDrive 300 to iGrow 1400

      Click for information for the iDrive 300 to the iGrow 1400.