Connecting an iDrive with a Thermostat
IDRIVE – to - THERMOSTAT
To wire the iDrive to a Thermostat, it would have to be a two-stage low voltage thermostat that can dry switch the OPEN, CLOSE and COMMON (J1 1/2/3) Terminals on the Master iDrive based on a temperature setting.
You would need a thermostat that you can dry switch between the Common and
HEAT (close signal) and COOL (Open Signal) See the image:
If you have any more questions or if you need assistance please give us a call at (714) 975-9474 or email us at support@link4Corp.com
Related Articles
iDrive Troubleshooting
iDrive (* 1 iDrive per motor*) The iGROW is just dry switching contacts that the iDrive receives. Master into a Slave On the J2 PCB #3  (to 24VAC transformer) remove and INDEPENDENTLY cap off. Slave - Make into a Slave J1 on circut board (9 - 10 ...iDrive - 970-0013-XXM Single Phase 3 wire
Attached is wiring information associated with the model number you provided 970-0013-xxM If you’re attaching the iDrive to a Ridder Motor, we do have videos on how to set the Limit Switching Ridder Motors I - Overview & Wiring a Ridder Motor Ridder ...iDrive - Linking to 1200/1400/1600/1800 Series Enviormental Controller
Before you Link Your iDrive Motor Controller to the 1000 Series Controller You must make sure that the iDrive Manual Switch Opens and Closes your Vent/Shade Curtain/Louver without any problems, and if limits switches are involved that they are ...iDrive 300 to iGrow 1400
Click for information for the iDrive 300 to the iGrow 1400.Daisy Chaining iDrive 150 DCP
Can the iDrive 150DCP be daisy chained like the 300M’s? The answer is yes, but you still need to remove the 24V and COM from the slave iDrive PCB.