LinkConn 1000
*1000 Series Port Issues
1000 Series Port Issues Greyed Out – In LinkConn, the iGrow is completely greyed out. Check the Com Port for any changes. USB to Serial Converter - Will omit problems with on board serial ports & Windows com port drivers. When you plug the USB to ...
How to obtain a new authorization key for the iControl 1000 Software
In order to obtain a new authorization key to use your iControl 1000 software with the iGrow 1000 series controller do the following: 1.) Have a paperclip handy and be in front of the iGrow unit(s) you need an auth key for. 2.) Beneath the toggle ...
iGrow 1400 Save and Restore with LinkConn Software Tutorial
Click the link below for a tutorial on saving and restoring your iGrow 1400 system using the LinkConn software.
LinkConn 1000 Software Installation
Click below for instructions on installing your software.
LinkConn 1000 Email Notification Process
Click below for the LinkConn 1000 email notification process.
Saving/Downloading Config
SAVING/DOWNLOADING CONFIGURATION Insert USB stick into controller OK> Save/Restore Config> Save Configuration Enter the name of your file and press OK You can now take the USB memory stick to a computer to retrieve your file.
iGrow 1000 - Key Generation
iGrow 1000 Key Generation You will need to go into Diagnostic mode in order to do this. On the front of the controller, on the right side bellow all the toggles, is a small pin hole "reset". Press reset and hit PREV|NEXT at same time. Once both ...
LinkConn Troubleshooting
LINKCONN TROUBLESHOOTING Serial Port Error Do you have the COMM cable wired in on the RS232-2 Port or plugged in to DB9 Serial Port on face of controller? Go To Device Mgr Pull usb out and then plug in. The device list will close & expand | identify ...
**** LinkConn - Computer Requirements
LINKCONN - Software Key Generation & Installation of Current Revised Editions Registering Component; you would need a key. 1000 series – key for all 100 series – key per unit 1000 Series Process (pre existing software) On the iGrow, reset the device ...