iGrow 1000 - Key Generation

iGrow 1000 - Key Generation

iGrow 1000 Key Generation

  • You will need to go into Diagnostic mode in order to do this.
  • On the front of the controller, on the right side bellow all the toggles, is a small pin hole "reset".
  • Press reset and hit PREV|NEXT at same time.

Once both lights above the buttons are lit, you have entered the diagnostic mode and a six character string will be displayed.  You need this string (case sensitive) to generate a key.

    • Related Articles

    • **** LinkConn - Computer Requirements

      LINKCONN - Software Key Generation & Installation of Current Revised Editions Registering Component; you would need a key. 1000 series – key for all 100 series – key per unit 1000 Series Process (pre existing software) On the iGrow, reset the device ...

    • How to obtain a new authorization key for the iControl 1000 Software

      In order to obtain a new authorization key to use your iControl 1000 software with the iGrow 1000 series controller do the following: 1.) Have a paperclip handy and be in front of the iGrow unit(s) you need an auth key for. 2.) Beneath the toggle ...

    • iGrow 800 Understanding Videos

      Please view the following videos in the order that there in, so you can program your controller with confidence, and also have an understanding of what Setpoints are for, Staging of your equipment in Temperature and Humidity Stages, as well as how to ...

    • iGrow 1400 Manual

      Attached, you will find the iGrow 1400 manual.

    • iGrow 800 Start Up Information

      Attached is an iGrow800 Manual, iDrive 300 Manual, wiring diagram for your Temperature & Humidity Senso