How to obtain a new authorization key for the iControl 1000 Software
In order to obtain a new authorization key to use your iControl 1000 software with the iGrow 1000 series controller do the following:
1.) Have a paperclip handy and be in front of the iGrow unit(s) you need an auth key for.
2.) Beneath the toggle switches on the right hand side of the iGrow is a small hole with the word "reset" beneath it.
3.) Put the paper clip in the hole to press the reset button and then quickly press and hold the "prev" and "next" keys when the screen goes blank.
4.) You will now be presented with a diagnostic screen with a 6 digit code.
5.) Make note of this code and then go ahead and reset the iGrow with the paper clip to get out of diagnostic mode.
6.) Send an e-mail to support@link4corp.com requesting a new key for your iControl 1000 software and include the 6 digit code from the diagnostic screen. Alternatively you can call +1 (714) 975-9474 and give the customer service representative the 6 digit code and he/she can give you the key verbally.
Related Articles
iControl Web Based Software
In regards to your question on viewing the controller from a web browser The 1000 series Controllers are software viewable only The 100 series Controllers (iGrow 400 & 800) give you the option to view it from the following views VCM and VCS VCM - ...
LinkConn 100 Software Installation Overview
LinkConn 100 Software Hardware Architecture To create this type of Topology Layout for your Green House Controller Before you install LinkConn 100 on your Controller Network, you will need Communication Modules on your controllers. If you have more ...
Preview the New iPonic 624
THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM. https://link4controls.com/link4_controllers/ Click below for a preview of the new iPonic 624, the latest release in the 600 Series!
iGrow 1000 - Key Generation
iGrow 1000 Key Generation You will need to go into Diagnostic mode in order to do this. On the front of the controller, on the right side bellow all the toggles, is a small pin hole "reset". Press reset and hit PREV|NEXT at same time. Once both ...
LinkConn 1000 Software Installation
Click below for instructions on installing your software.