Before you Link Your iDrive Motor Controller to the 1000 Series Controller You must make sure that the iDrive Manual Switch Opens and Closes your Vent/Shade Curtain/Louver without any problems, and if limits switches are involved that they are ...
Please view the information provided and attached to assist you in resolving your iDrive Issues. Please contact us with your findings at (714) 975-9474 or email us at support@link4Corp.com
When Running Your High Voltage to your iDrive Enclosure, it is important you drill your holes thru the bottom make sure you use water tight connectors to keep out any moisture or water that can damage the iDrive components. we recommend not to Drill ...
Converting iDrive MASTER into a iDrive SLAVE To convert a iDrive Master into an iDrive Slave you would do the following: · On the J2 portion of the PCB board on the door of the iDrive · Remove the #3 & #2 (to 24VAC transformer) and INDEPENDENTLY cap ...
To convert your Master IDrive into a Slave iDrive you would open the iDrive Door and on the backside of the Door on the J2 Portion of the PCB on the top left corner, you would pull the Yellow and Blue wire and cap independently