iDrive - Dasiy Chaining Mulitple iDrives for Simultaneous Operation

iDrive - Dasiy Chaining Mulitple iDrives for Simultaneous Operation

Converting iDrive MASTER into a iDrive SLAVE
To convert a iDrive Master into an iDrive Slave you would do the following:
·         On the J2 portion of the PCB board on the door of the iDrive
·         Remove the #3 & #2 (to 24VAC transformer) and INDEPENDENTLY cap off.
 
 
 
DASIY CHAIN – iDrives 
 
 
 
 
 
If you have any more questions or if you need assistance please give us a call at (714) 975-9474 or email us at support@link4Corp.com

    • Related Articles

    • iDrive - Converting Master iDrives into Slave iDrives

      To convert your Master IDrive into a Slave iDrive you would open the iDrive Door and on the backside of the Door on the J2 Portion of the PCB on the top left corner, you would pull the Yellow and Blue wire and cap independently

    • Daisy Chaining iDrive 150 DCP

      Can the iDrive 150DCP be daisy chained like the 300M’s? The answer is yes, but you still need to remove the 24V and COM from the slave iDrive PCB.

    • iDrive Troubleshooting

      iDrive (* 1 iDrive per motor*) The iGROW is just dry switching contacts that the iDrive receives. Master into a Slave On the J2 PCB #3 &#2 (to 24VAC transformer) remove and INDEPENDENTLY cap off. Slave - Make into a Slave J1 on circut board (9 - 10 ...

    • iDrive - 970-0013-XXM Single Phase 3 wire

      Attached is wiring information associated with the model number you provided 970-0013-xxM If you’re attaching the iDrive to a Ridder Motor, we do have videos on how to set the Limit Switching Ridder Motors I - Overview & Wiring a Ridder Motor Ridder ...

    • iDrive Troubleshooting guide

      Please view the information provided and attached to assist you in resolving your iDrive Issues. Please contact us with your findings at (714) 975-9474 or email us at support@link4Corp.com