iGrow 100 LinkConn Issues

iGrow 100 LinkConn Issues

100 Series LinkConn Issues

 

My LinkConn Software cannot see my controller.

SystemSetup>CommunicationSetup>MODBUS

In Modbus settings

  • Modbus communication:  Remote or Broadcast
  • Modbus address:  1 – 242 if you have more than one controller use different numbers
  • NetworkName:  make sure controller has a unique name (not Zone #1)

IP Address settings  (all must be valid.)

  • input address
  • subnet mask
  • Gateway

 

Serial Cable Testing

  • Use tone or continuity tester
  • 1 is B Position on the Comm Mod
  • 2 is Red
  • Download driver at FTDI

 

On the web browser address bar, type in the assigned IP designated for controller and you will be able to control you device from the web browser using your mouse pointer to control interface.

    • Related Articles

    • *1000 Series Port Issues

      1000 Series Port Issues Greyed Out – In LinkConn, the iGrow is completely greyed out. Check the Com Port for any changes. USB to Serial Converter - Will omit problems with on board serial ports & Windows com port drivers. When you plug the USB to ...

    • iGrow 800 - VCM and VCS Issues

      VCM and VCS VCM - Must have the LinkConn software installed | has to be running on a PC | use Remote Desktop to access LinkConn from a different PC. (team viewer, netviewer, web ex) VCS – (not cloud) Allows you to access controller from a Browser ...

    • *iGrow 100 Series Network Connectivity Issues

      100 Series NETWORK CONNECTIVITY S Com Module (Methods of remote access) RS485 – uses LinkConn Software | need license | firmware RG45 – uses webserver (network capabilities) | firmware iGrow100 Comm Module (Rabbit) Need to power off when installing ...

    • iGrow 800 Sensor Issues

      If your sensor issues persist, please view the following video link to assist you in troubleshooting your sensor issues.

    • LinkConn Troubleshooting

      LINKCONN TROUBLESHOOTING Serial Port Error Do you have the COMM cable wired in on the RS232-2 Port or plugged in to DB9 Serial Port on face of controller? Go To Device Mgr Pull usb out and then plug in. The device list will close & expand | identify ...