1000 Series Rain Sensor Stand Alone Wiring and Installation

Here is information for wiring up your Rain Sensor to the iGrow1000 Series Controller

View the following link before installing, attached is information as well. 

 

 

 

 

Rain Sensor Dip Switch Setting Information 

 

 

• Related Articles

• iGrow 800 - Rain Sensor Stand Alone Installation

  Please View the following Method in Installing the Stand Alone Rain Sensor to the iGrow 400/800 Controller. Attached to this Article is a Rain Sensor Manual, and here is a video link on installing and mapping the Rain Sensor to the controller.

• iGrow 800 - Anenometer Stand Alone Installation

  Please View the following Method in Installing the Stand Alone Anemometer to the 100 Series Controller. Attached to this Article is a Anemometer Manual, and here is a video link on installing and mapping the Anemometer to the controller.

• 1000 Series - Rain Sensor Troubleshooting

  Please view the following information to assist in troubleshooting your RAIN SENSOR. 1st try a soft Reset to see if your rain sensor will react to RAIN If the soft reset does not work Check the Sensor Mapping Test The FDIn2 Port on the Controller and ...

• 1000 Series Barometric Pressure Sensor Wiring and Installation

  Barometric Pressure Sensor needs to be mounted outside, to measure pressure externally from Greenhouse. You would mount the sensor at one of the Analog outputs (1 thru 5) and you would map as an analog sensor. Since the sensor is semi-sealed, minimum ...

• 1000 Series Anemometer Installation

  Please View the following Method in Installing the Stand Alone Anemometer to the 1000 Series Controller. Attached to this Article is a Anemometer Manual, and here is a video link on installing and mapping the Anemometer to the controller. iGrow 1400 ...