iGrow 800 - Rain Sensor Stand Alone Installation

iGrow 800 - Rain Sensor Stand Alone Installation


Rain_Sensor_1.png
 
Please View the following Method in Installing the Stand Alone Rain Sensor to the iGrow 400/800 Controller.
 
Attached to this Article is a Rain Sensor Manual, and here is a video link on installing and mapping the Rain Sensor to the controller.

Rain_Sensor_Exploded_View.png
 
Rain_Sensor_2.png
 
100_Series_Rain_Sensor.png
 
Sensors_Wired_View_3.png
 
Rain_Sensor_Mapping.png

    • Related Articles

    • iGrow 800 - Anenometer Stand Alone Installation

      Please View the following Method in Installing the Stand Alone Anemometer to the 100 Series Controller. Attached to this Article is a Anemometer Manual, and here is a video link on installing and mapping the Anemometer to the controller.

    • 1000 Series Rain Sensor Stand Alone Wiring and Installation

      Here is information for wiring up your Rain Sensor to the iGrow1000 Series Controller View the following link before installing, attached is information as well. Rain Sensor Dip Switch Setting Information

    • 1000 Series Anemometer Installation

      Please View the following Method in Installing the Stand Alone Anemometer to the 1000 Series Controller. Attached to this Article is a Anemometer Manual, and here is a video link on installing and mapping the Anemometer to the controller. iGrow 1400 ...

    • iGrow 800 - Solar Sensor Installation

      The Solar Light Sensor offers an accurate, yet cost effective tool to measure solar energy. With a universal mounting bracket and 50ft of cable, this light sensor can be placed inside or outside your greenhouse for: the sensor can be used for the ...

    • 1000 Series - Rain Sensor Troubleshooting

      Please view the following information to assist in troubleshooting your RAIN SENSOR. 1st try a soft Reset to see if your rain sensor will react to RAIN If the soft reset does not work Check the Sensor Mapping Test The FDIn2 Port on the Controller and ...