iGrow 100 Analog Probe Wiring & Progamming

• Related Articles

• iGrow 1400 - Analog Temp Probe Troubleshooting

  THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM. https://link4controls.com/link4_controllers/ If your Analog Probe is displaying wrong readings, spiking up and down or not reading at all its time to take steps in ...

• How to Connect a Solar Light Sensor to an Analog Input Module | Link4 Controls

  The Solar Light Sensor needs voltage (+12VDC) to power it and it outputs a current which is passed through a resistor (3.8K R6) for the controller to measure the voltage that corresponds to the light level. There are 3 ways to do this, listed below ...

• iGrow 800 - Analog Temp Sensor Averaging

  Analog Sensor Averaging: This option allows the user to average the data from separate analog sensors. For Sensor Averaging you would need to install multiple Analog Probes at strategic locations in greenhouse to get an overall temperature average. ...

• iGrow 800 - Temperature Probe Installation

  Please view the following in installing Analog Temperature Probes on the iGrow400/800 Controller. Once you have landed your Temp Probe you would have to go into the Controllers Programming to Map the Sensor to the controller

• PEARL - Analog Temperature Probe Installation on 5 Input Module

  The Pearl Analog Temp Probe Sensor would be wired to your 5 Input Module in the following way: The Red Wire of Temperature Probe would go to 3V on bottom of Module the White Wire would go to the (+) of the Input you are going to use for the Temp ...