Barometric Sensor Connection

Barometric Sensor Connection


    • Related Articles

    • 1000 Series Barometric Pressure Sensor Wiring and Installation

      Barometric Pressure Sensor needs to be mounted outside, to measure pressure externally from Greenhouse. You would mount the sensor at one of the Analog outputs (1 thru 5) and you would map as an analog sensor. Since the sensor is semi-sealed, minimum ...

    • iGrow 800 - Rain Sensor Stand Alone Installation

      Please View the following Method in Installing the Stand Alone Rain Sensor to the iGrow 400/800 Controller. Attached to this Article is a Rain Sensor Manual, and here is a video link on installing and mapping the Rain Sensor to the controller.

    • iGrow 800 Analog Sensor Troubleshooting

      Please take the following steps in troubleshooting your Temperature Probe. iGrow 100 Series Sensor Troubleshooting Temperature sensor is fluctuating or not registering at all Check sensor connection wires on the controller make sure there snug & ...

    • iGrow 800 Sensor Jumping issues

      Please take the following steps in troubleshooting your Temperature Probe. · iGrow 100 Series Sensor Troubleshooting - Check connection’s inside junction box (if one exists) for moisture or corrosion - Check the PCB for corrosion, moisture or ...

    • ***** iGrow Sensor Info, Issues and Troubleshooting

      iGrow 100 series Sensor Issues Outdoor/Indoor Temp/Hum Sensor Troubleshooting Temperature sensor not registering. Check sensor connection wires on the controller to make sure there tight and securely fastened. Check connections inside junction box ...