Communications
iGrow 1400 - Communications - Network Wire Installation
THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM. https://link4controls.com/link4_controllers/ Whether you need to setup multiple zones, add expansion units, or both, creating a network for the iGrow1400 ’s is simple. ...
iGrow 1400 - Communications - Network Programming
THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM. https://link4controls.com/link4_controllers/ Once multiple iGrow 1400 controllers are wired together, you will need to set up each iGrow's program settings for proper ...
iGrow1400 - iPhone|Android Access
THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM. https://link4controls.com/link4_controllers/ With an iPhone you can see the current status of a controller & its network as if looking from LinkConn 1000 Software 1st - ...
iGrow1400 - Communication options
THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM. https://link4controls.com/link4_controllers/ With the iGrow 1000 Series Controller, you have a variety of communication options you can use to connect to your controller via ...
iGrow1400 - Communications Troubleshooting
THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM. https://link4controls.com/link4_controllers/ Troubleshooting Zones 1st - Make sure all wires linking each controller at the RS485 Terminal Port are snug, tight, and ...
1000 Series - Checking Continuity on 3 wire DB9 Pigtail
THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM. https://link4controls.com/link4_controllers/ To Test your 3 wire Pigtail, you will do the following: The Pig Configuration for the Pigtail is: RX (Red) is for the #2 Pin GND ...