THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM.

(MUST HAVE A LOW VOLTAGE INTERFACE & BUILT-IN THERMOSTATIC CONNECTIONS)

Low Voltage Contact Closure  -- MUST HAVE A THERMOSTAT TERMINAL AND A 24V DRY CONTACT

Cooling - Do you have a sealed or non-sealed environment?

• Sealed : A/C - Dedicated HUM/DEHUM ?

• Non Sealed: Exhaust Fan 

Can my iPonic have 2 different AC zones?

• As long as it provides low voltage wiring, FOR EACH ZONES.

iPonic AC/HEATER Applications

To wire an AC/Heater you will need to devote three outputs:

• 1 for the fan/blower
• 1 for the A/C
• 1 for the furnace.

The 5 output would be heater, which is pre-wired to output 5 (Which is by system default, the output assigned for a heater.)

The AC wired to output 8 and the unit fan wired to output 7.

A/C HOOK UP PITCH 

Does it have thermostatic low voltage wiring?

• Relays 7 & 8 are wired as a dry contact, (no Voltage). 
• When the relay is  On   the “+” terminal is connected to the “–“ terminal. 
• When the relay is  Off   the terminals are disconnected.

How do I Connect to an Irrigation Valve?

Option A using channel 7 or 8

• Wire one side to the common side of the valve
• Wire the other side of the supply on channel 7/8 (+/-)
• Wire back to the valve.

Option B plug 24V P/S directly into the iPonic

(It should fit on outlets 3 or 6) and wire to the valve. 

What are the Analog Inputs for on the iPonic PCB?

• They are for testing purposes (in reality they are not applicable | there for 100series board)

Equipment with Manual Turn on   -- will the iPonic turn it on for me manually?

• If a device has to be manually turned on after power interruption | the iPonic will not turn it on
• iPonic only switches high voltage.