System Setup - VPD Settings (Canopy Sensor)

This is the Location where you This is where you select the sensor that is measuring the plant temperature for the VPD measurement Press the Up or Down key to select the sensor

To get to VPD Settings you would do the following:

• Related Articles

• Pearl Control System Manual - V1.18.2 (May 2026)

  For detailed instructions and important information on the Pearl Control System, please refer to the attached manual. It contains everything you'll need to get started and use the control system effectively. Edit: Version 1.18.2 Manual Attached.

• Irrigation Programming - Vapor Pressure Deficit (VPD) Accumulation Irrigation

  Another advanced on-demand irrigation equipment type for the Pearl is the Vapor Pressure Deficit (VPD) accumulation mode. VPD is the difference (referred to as deficit) between the amount of moisture in the air and how much moisture the air can hold ...

• System Setup - Fallback Settings

  If the user encounters a 3-minute Timeout Error, the system switches to a backup plan, which is called the Fallback Setting. In this, the system defaults to predefined settings for Heating or Cooling stages to maintain the desired temperature range ...

• System Setup - System Units

  With the Peal Controller you can set a variety of System Units to best suite your grow needs Temperature Choose either degrees Fahrenheit (ºF) or degrees Centigrade (ºC). Wind Speed Choose either miles per hour (mph) or kilometers per hour (km/h). ...

• System Setup - Generic Sensor

  The Pearl has been designed to deliver a high level of flexibility for the advanced growers who often have needs for specialized equipment and controls. One of these features is the ability to support up to 128 generic sensors. To setup your Generic ...