System Setup - Time/Date & History

Time Time adjusts the current time by highlighting the field and pressing either the UP or DOWN keys.

Date Do the same for the date. Press LEFT/RIGHT to go from field to field and adjust the correct date.

Daylight Savings If you want the program to automatically adjust itself for Daylight savings time.

Timezone Hrs. Adj : Select your current time zone, e.g. Los Angeles is -8 hrs (PDT) or -7 hrs (PST)

     Note: If the controller is connected to the internet, the time will be automatically adjusted and synced.

     However, you need to set your timezone to your current location. Do not adjust the time manually.

To get to Time / Date & History you would do the following:

• Related Articles

• Pearl Control System Manual - V1.18.2 (May 2026)

  For detailed instructions and important information on the Pearl Control System, please refer to the attached manual. It contains everything you'll need to get started and use the control system effectively. Edit: Version 1.18.2 Manual Attached.

• PEARL Control System User Manual V.1.17.284

  Attached is the updated Pearl manual.

• System Setup - Fallback Settings

  If the user encounters a 3-minute Timeout Error, the system switches to a backup plan, which is called the Fallback Setting. In this, the system defaults to predefined settings for Heating or Cooling stages to maintain the desired temperature range ...

• System Setup - System Units

  With the Peal Controller you can set a variety of System Units to best suite your grow needs Temperature Choose either degrees Fahrenheit (ºF) or degrees Centigrade (ºC). Wind Speed Choose either miles per hour (mph) or kilometers per hour (km/h). ...

• System Setup - Set Up Inputs

  Setup Inputs is where the user defines which sensors the Pearl™ will use, a process also known as sensor mapping. The screen above shows the typical sensor mapping for each sensor. If there is no particular sensor used, then leave the setting as None ...