Sensor dashboard walkthrough and configuration

How to configure the sensor board:

• Related Articles

• Equipment dashboard walkthrough

• Zone dashboard overview

• System Setup - Generic Sensor

  The Pearl has been designed to deliver a high level of flexibility for the advanced growers who often have needs for specialized equipment and controls. One of these features is the ability to support up to 128 generic sensors. To setup your Generic ...

• System Setup - VPD Settings (Canopy Sensor)

  This is the Location where you This is where you select the sensor that is measuring the plant temperature for the VPD measurement Press the Up or Down key to select the sensor To get to VPD Settings you would do the following:

• How to Connect a Solar Light Sensor to an Analog Input Module | Link4 Controls

  The Solar Light Sensor needs voltage (+12VDC) to power it and it outputs a current which is passed through a resistor (3.8K R6) for the controller to measure the voltage that corresponds to the light level. There are 3 ways to do this, listed below ...