iGrow1400 - Checking Firmware Version

After you have installed the Rabbit Main Module, if you were to hit Help 2 times the Welcome Screen is displayed showing your most current firmware the controller is on.

 

Here the Firmware Version is 1.04.17

Note, we do not necessarily change the copyright date each time we do a revision of our software or firmware.

• Related Articles

• iGrow 800 - Checking Firmware Version

  To check the version of the controller please do the following: OK-> 3. System Setup-> 10. Advance->unit info (Button #4) Your Controller may be an iGrow800 M which is for Link Conn 100 Software use. Or it may be iGrow800 C which it used for iGrow ...

• Updating the Digital Version of the Pearl Firmware Using a USB Stick

  The Pearl firmware can be updated remotely using the cloud (OTA - over the air). However, there are installations where the internet connection is either non-existent or too unstable for a reliable update. The Pearl controller can also be updated ...

• Pearl/Hydroroot Controller Firmware Update Guide using USB Stick

  Save the firmware (bin) file to the USB stick. Insert the USB stick in the upper left slot. Navigate to Menu System- Press ENTER Navigate to Firmware Press ENTER to highlight Press ENTER to enter Firmware Menu Press ENTER to highlight Update Use UP ...

• Hydroroot Firmware Update Guide using USB Stick [rev 1.1]

  Save the firmware (bin) file to the USB stick. For Hydroroot units only, save the Menu file to the USB stick along with the firmware file. The Hydroroot menu file should have “HydroRoot” and “Menu” in the file title. If you are updating a Pearl unit, ...

• iGrow 1400 - Updating Firmware Process

  To upgrade your firmware on your iGrow 1400 controller, you would need to contact Link4 Sales or Support and pick up the following: 1000 Series Programming Cable Firmware USB to Serial Converter RFU Software. Once these items have been obtained, you ...