iGrow 800 Weather Station Network Troubleshooting

iGrow 800 Weather Station Network Troubleshooting

What we need do is use deductive reasoning in isolating the issue and find the problem that is causing the Communication Breakdown.
 
·  Check 12V power supply (is it rigid) it could be marginal, and could be pushed to the edge, this could in fact be messing with the 3v that control the logic (like Communications)
·   Swap Comm Modules, (make sure power them down before detaching)
·   Bypass Controllers Completely (By lifting Blue Plastic Relay off of Comm Mod)
·    We Want to at least Get 2 controllers talking, and then build from that, adding 1 controller to the network chain at a time.

    • Related Articles

    • iGrow 800 - Weather Station Installation

      Here is information for wiring up your weather station to the iGrow100 Series Broadcast Controller View the following link before installing your weather station, attached is information as well. The upper Terminal Block is for your Wiring to the ...

    • iGrow 800 - using Modbus to for Weather Station and Linkconn 100

      With the iGrow 800 Controller, you can Use Modbus to Share Weather Station readings amongst all the controllers within the network, as well as view multiple controllers via Link Conn 100 When Setting up Modbus, you would first need to network (Hard ...

    • iGrow 1400 - Communications - Network Programming

      THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM. https://link4controls.com/link4_controllers/ Once multiple iGrow 1400 controllers are wired together, you will need to set up each iGrow's program settings for proper ...

    • iGrow 1400 - Communications - Network Wire Installation

      THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM. https://link4controls.com/link4_controllers/ Whether you need to setup multiple zones, add expansion units, or both, creating a network for the iGrow1400 ’s is simple. ...

    • 1000 Series - Weather Station Installation

      Here is information for wiring up your weather station to the iGrow1000 Series Site Master Controller View the following link before installing your weather station. Attached is information as well.