Please view the following videos in the order that there in, so you can program your controller with confidence, and also have an understanding of what Setpoints are for, Staging of your equipment in Temperature and Humidity Stages, as well as how to Program your equipment.
iGrow 800 – Setpoint Programming
iGrow 800 - Setting up your equipment ON/OFF Devices
iGrow 800 Setting up your equipment for Temperature & Humidity Stages.
When setting up 2 speed fans make sure that the low speed and the High speed are not on the same stage. They must not be on at the same time.
Note: Attached is a 100 series manual that’s for the iGrow 400 and 800 controller
Attached is the iGrow 1800 User Manual Also here is a list of video links to assist you in obtaining a General understanding of how to program the iGrow1800 controller.
THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM. https://link4controls.com/link4_controllers/ Here are a couple of video links to get to iPonic 624 Training Videos. iPonic Essential Training ...
THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM. https://link4controls.com/link4_controllers/ Here are a couple of video links to get to iPonic Training Videos iPonic Essential Training Playlist: ...
For detailed instructions and important information on the Pearl Control System, please refer to the attached manual. It contains everything you'll need to get started and use the control system effectively. Edit: Version 1.17.18 Manual Attached.
Here are a few links to assist you with your LinkConn 1000 installation process, attached is a manual. LinkComm 1000 download http://file.link4corp.com/software-download/LinkConn_1000_v3.6.2.0.zip Driver for USB to Serial Cable ...