Please view the following videos in the order that there in, so you can program your controller with confidence, and also have an understanding of what Setpoints are for, Staging of your equipment in Temperature and Humidity Stages, as well as how to Program your equipment.
iGrow 800 - Sensor Setup
iGrow 800 – Setpoint Programming
iGrow 800 - Setting up your equipment for Temperature & Humidity Stages.
iGrow 800 - Setting up your equipment ON/OFF Devices
iGrow 100 - Curtain Programming
iGrow 800 - Equipment Setup (VENTS)
When setting up 2 speed fans make sure that the low speed and the High speed are not on the same stage. They must not be on at the same time.
THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM. https://link4controls.com/link4_controllers/ Click the link below for additional information on programming equipment for the iGrow 1400.
Vent (Proportional) Programming Note: This equipment type requires 2 consecutive output channels 1&2, 3&4, etc. The first channel (odd numbered) must be wired to OPEN the vent, and the other (even numbered) to CLOSE it. Here is a video to give you a ...
Curtains requires 2 consecutive output channels.(1&2, 3&4, 5&6, 7&8). The first channel (odd numbered) must be wired to Uncover/Open Curtain, and the other (even numbered) to Cover/Close Curtain. Click the link below for additional information on ...
With the iGrow 800 Controller, any one of the available 8 channels can be selected to be an alarm output. Click the link below for information on programming an alarm for an iGrow 800 controller. Set Temperature: lets you select the temp threshold ...