iGrow 800 Communications with Computer

iGrow 800 Communications with Computer

VCM and VCS
VCM - Must have I control | has to be running on a PC | then use Remote Desktop to access icontrol from a different PC. (team viewer, net viewer, web ex)
VCS – (not cloud) allows you to access controller from a Browser Enabled Device. WITHIN THE NETWORK!
·         You would type in the ip of the controller in browser address line which would allow you to see it.
·         The Webpage displayed shows Front View of Controller – fully functional with mouse cursor.
o   Example on Company’s Network ip address 192.168.50.240
VCM
VCS
  • Icontrol
  • NO Icontrol
  • No Web Browser
  • Web Browser
  • Can remote in Via Team viewer or Web Ex and see your iControl Software Via the desktop From iPhone
  • NOTIFICATIONS
  • Cannot Remote in to see I Control Software
 
For VCM IP Address settings  (all must be valid.)
·         input address | subnet mask | Gateway
·         On web browser address bar type in the assigned IP designated for controller and you will be able to control  you device from the web browser using the mouse pointer to control interface

    • Related Articles

    • iGrow 1400 - Communications - Network Wire Installation

      THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM. https://link4controls.com/link4_controllers/ Whether you need to setup multiple zones, add expansion units, or both, creating a network for the iGrow1400 ’s is simple. ...

    • iGrow 1400 - Communications - Network Programming

      THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM. https://link4controls.com/link4_controllers/ Once multiple iGrow 1400 controllers are wired together, you will need to set up each iGrow's program settings for proper ...

    • iGrow1400 - Communications Troubleshooting

      THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM. https://link4controls.com/link4_controllers/ Troubleshooting Zones 1st - Make sure all wires linking each controller at the RS485 Terminal Port are snug, tight, and ...

    • iGrow 1400 Manual

      Attached, you will find the iGrow 1400 manual.

    • iGrow 400 Communications Information

      To wire your Controller for LinkConn 100 Software, you would do the following: After you have Hardwired your Installation, you must program the controller and the PC to communicate FROM THE CONTROLLER SystemSetup>Communication Setup>MODBUS In Modbus ...