iGrow 800 Checking Continuity & Repair Address

iGrow 800 Checking Continuity & Repair Address

Here is the Video Link on Checking Continuity with your iGrow 800 Controller

iGrow 100 Series Checking Continuity



 
As for the Repair, you can send the controller in, and our factory can run tests to determine reasons behind the buttons not working.
 
There would be a $100 fee that would go towards, inspection, repairs, parts, and labor.
 
Shipping is not included.
 
Please send controller to the following address:
 
Link 4 Corporation
22725 La Palma Ave.
Yorba Linda, CA 92887

    • Related Articles

    • iGrow 1400 Checking Outputs Continuity Video

      Click the link below for additional information on checking the iGrow 1400's continuity.

    • 1000 Series - Checking Continuity on 3 wire DB9 Pigtail

      THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM. https://link4controls.com/link4_controllers/ To Test your 3 wire Pigtail, you will do the following: The Pig Configuration for the Pigtail is: RX (Red) is for the #2 Pin GND ...

    • iGrow 800 Understanding Videos

      Please view the following videos in the order that there in, so you can program your controller with confidence, and also have an understanding of what Setpoints are for, Staging of your equipment in Temperature and Humidity Stages, as well as how to ...

    • iGrow 1400 - Checking the controllers Step Down Voltage

      THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM. https://link4controls.com/link4_controllers/ With The iGrow 1400 the controller needs 12vdc voltage to power the unit. the Controller has a Voltage Regulator which is needed ...

    • iGrow 800 Wiping Controller & Repair Options

      If the firmware update does not resolve the Random Freezing of the Screen, please take the following steps to format file system (A) SAVE EXISTING CONFIGURATION SETTINGS (set points/equipment settings/stages). To save your configuration you would do ...