Here is the Video Link on Checking Continuity with your iGrow 800 Controller iGrow 100 Series Checking Continuity As for the Repair, you can send the controller in, and our factory can run tests to determine reasons behind the buttons not working. ...
Once you have your expansion Board Hardware installed, your equipment operating successfully from toggle switches and your Dip switches addressing set on expansion board accordingly, it’s time to program the software portion of expansion boards. Here ...
THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM. https://link4controls.com/link4_controllers/ To Test your 3 wire Pigtail, you will do the following: The Pig Configuration for the Pigtail is: RX (Red) is for the #2 Pin GND ...
With the iGrow1800, Outputs control allows you to influence the order of operation, adding additional features to obtain the best results in your greenhouse operation. Here is a video for a more in depth understanding: Now to Program Outputs Control ...