With your iDoser, you can set up EC/pH Alarms Now here is a video - iDoser Environmental Controller EC / ph Alarm Setup <br> To Program hit Enter/Menu->iDoser Programming->EC/pH Alarms In the first screen you will assign the tank for ...
The Input Multiplier option is for calibrating the outside light sensor or a CO2 sensor, if you have one. The Raw Value is the actual reading from the sensor. The Factor for the light sensor is the multiplier adjustment. Use the UP or DOWN keys to ...
The Pearl topology refers to various modes of the controllers. Controllers can be set to these modes: Gateway: The controller that is connected to the weather station. It will broadcast the weather station data to all the other controllers through ...
Setup Inputs is where the user defines which sensors the Pearl™ will use, a process also known as sensor mapping. The screen above shows the typical sensor mapping for each sensor. If there is no particular sensor used, then leave the setting as None ...
In order to set up one of your outputs to be an ALARM, you would need to take the following steps: On the controller you would press OK->SystemSetup->Equipment Setup-> on the equipment menu you want to choose an output to be an alarm OK-> Then under ...