24V Power Supply to the iPonic Channel
Here is a diagram on how you would attach your Damper to the iPonic.
Related Articles
iPonic Power Issues
THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM. https://link4controls.com/link4_controllers/ POWER ISSUE RESOLVE FOR IPONIC the iPonic Controller Max Amp Load Capacity is 15 Amps if you plan on running Hi Current draw ...iPonic Power Issues
THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM. https://link4controls.com/link4_controllers/ if your iPonic controller has no power at all, make sure the 15 Amp Circuit Breaker is not popped out. If the 15 Amp Breaker is ...iPonic Power Issues - Flickering LIght LED or NO POWER at all
THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM. https://link4controls.com/link4_controllers/ On the Door PCB is the POWER LED lit up or is it Flickering. Please take the following steps to check why the controller is not ...**iPonic A/C & FAQs
THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM. https://link4controls.com/link4_controllers/ (MUST HAVE A LOW VOLTAGE INTERFACE & BUILT-IN THERMOSTATIC CONNECTIONS) Low Voltage Contact Closure -- MUST HAVE A THERMOSTAT ...iGrow1400 - Power Issues - No Power LED
THIS PRODUCT HAS BEEN DISCONTINUED AND REPLACED BY THE PEARL CONTROL SYSTEM. https://link4controls.com/link4_controllers/ If your iGrow 1400 has no power, and the Power LED is not lit up and is Out on the back of the board, we need to take the ...